Sentence examples for maximum stabilization from inspiring English sources

The experimental results of an optimal linker length l=4 and a maximum stabilization of 1.7 kcal/mol are reproduced.

Five factors were considered, the five impedance spectroscopy measurement parameters: maximum integration time; minimum number of integration cycles; number of stabilization cycles; maximum stabilization time; and minimum cycle fraction.

Too long or too short a hydrophilic group length does not give maximum stabilization, due to the balance between solubility and the capacity for hydrophobic binding.

Thus, after allowing maximum stabilization of the tetrameric forms of both TTR wild type and Y78F mutant proteins by formation of TTR/inhibitor complexes of (1 2) stoichiometry, measures of circular dichroism in the far-UV of changes in the secondary structure of TTR were recorded as a function of time in 6M urea solutions.

The main focus of the majority of these works was of course on the optimization of the immobilization protocol with the goal of achieving maximum stabilization of TvDAO.

Figure 3 further depicts that the initial ammonia utilization rate was high and maximum stabilization of ammonium in solution was attained within 32 h, after which the utilization declined and ammonium was removed marginally.

The location of the corrective osteotomy and arthrodesis was determined according to radiologic and clinical assessment, and stabilization was performed using specific implants in order to achieve maximum stability.

Bhuvaneshwari et al. [8] concluded that when the flyash percentage was 25%, workability had been at the maximum for stabilization of expansive soils with flyash.

The optimum values of variables obtained for maximum laccase stabilization at higher temperature are pectin, 0.31%, carrageenan, 0.3% and pH, 4.4 with predicted percentage residual activity of 93.77%.

The optimum values of these variables for maximum laccase stabilization at 60 °C are Guar Gum (0.098%), starch (6.235%) and sodium acetate buffer (76.84 mM) with a predicted percentage residual activity of 69.91%.

Thus position of the ring nitrogen directly adjacent to the negatively charged catalytic residues is critically important for achieving the tightest binding, and the maximum possible stabilization effect.