Sentence examples for maximum specific volume from inspiring English sources

The power output, power density (ratio of power output to maximum specific volume in the cycle) and thermal efficiency of the cycle are derived.

The heating load density, i.e. the ratio of heating load to the maximum specific volume in the cycle, is taken as the optimization objective.

where VS is the specific volume of displaced mass when the factor of safety (FSJ) is smaller than one, and Vmax is the probable maximum specific volume that could collapse from the slope.

The power density, defined as the ratio of power output to maximum specific volume in the cycle, is taken as the optimization objective because it considers the effects of engine size as related to investment cost.

The heating load, the coefficient of performance (COP), and the heating-load density, i.e. the ratio of heating load to the maximum specific volume in the cycle, are the optimization objectives.

In this paper, the power density, defined as the ratio of power output to the maximum specific volume in the cycle, is taken as objective for performance analysis of an irreversible closed Brayton cycle coupled to constant-temperature heat reservoirs in the viewpoint of finite time thermodynamics (FTT) or entropy generation minimization (EGM).

The maximum occurs approximately after gelation, and the specific volume of the material after gelation increases via further crosslinking.

Three thin DWs (30, 50 and 70 mm) were compared with the typical thick DW (150 mm) and it was found that 50 and 70 mm DWs have the potentials in the compact cooling system with the maximum moisture removal capacity (MRCmax) based on specific volume (MRCmax/DW Volume) 1.2 and 0.7 times higher than that of 150 mm DW, respectively.

Eluate volumes (1.3 2 ml) of maximum specific radioactivity of 25 GBq/ml were routinely prepared.

Thermal treatment at 600°С and less process duration leads to more substantial changes in the pore specific volume and surface area, the maximum of which is observed at t mod  = 0.75 h.

The dough was immersed in the coating solution to be analyzed for maximum expansion factor, bread crumb and crust color, specific volume, crumb image and Scanning Electron Microscopy (SEM).