Sentence examples for maximum sorption was from inspiring English sources

The maximum sorption was observed at particle size 0.5 mm and pH 2.0.

The results show that maize husk biosorbed substantial quantity of Mn II) at lower pH, however, it was observed that the extent of sorption of Mn II) by the biosorbent decreases with increase in pH. Figure 2a shows that maximum sorption was observed at the pH 2.0 with the percentage removal of 93.4 for raw biosorbent (UTCS) and 88.4 for oxalic acid-modified biosorbent (ATCS).

The experimental data revealed that the maximum Pb II) sorption was possible at pH 5.0.

The Langmuir maximum equilibrium sorption was found to be 11.411 - 22.38 mg/g at different temperatures.

The 24-h equilibration time was determined by performing preliminary sorption experiments, in which maximum OC sorption was reached within 24 h.

For A. sp RBSS-303, insignificant difference was found in uptake value using biomass harvested after 24 144 h of incubation and the maximum sorption capacity was found to be 79.3 ± 0.25 mg/g dry weight.

The maximum sorption capacity was determined to be as high as 195.31 mg/g.

The maximum sorption capacity was found to be 92.59 mg L−1 at 30 °C.

The maximum sorption capacity was 0.493 mmol g−1 while the preconcentration factor was 250 for Ag+.

Several groups reported that the sorption of gas on coals at a given pressure increases with decreasing temperature (Azmi et al. 2006; Menon 1968; White et al. 2005; Zhou et al. 2001), but the temperature effect on the maximum sorption capacity was controversial (Sakurovs et al. 2010), nor was the temperature effect quantified.

According to Fig. 5, maximum CO2 sorption values related to polymer weight in pure ABS at saturation pressures of 3 and 5 MPa are 108 and 165 mg/g, respectively, while in the same situation, for APCN samples, these values (i.e., maximum CO2 sorption) were a little bit lower than the pure ABS samples.