Sentence examples for maximum signal being from inspiring English sources

Linear phase encoding was used, resulting in the maximum signal being detected 5 min after starting the acquisition.

The coverage signal on each bin was extracted using deeptools, and the bin with the maximum signal was used as the observed value.

Typically the maximum signal is desired, so the HETG and LETG observer is most likely to insist on all ACIS-S chips.

Maximum signal was obtained in 0.01 M for both states.

Optimisation of detector placement and design is required to ensure maximum signal is recovered.

The maximum signal is over the largest ocean mass concentration (central Pacific Ocean).

To properly normalize the reflectance values, the maximum signal was assigned a mean value of 1. Normalizing on the maximum SPR responses was to compare different array chips.

For both Gluc and FFluc, the maximum signal was obtained immediately after substrate addition with median values of 2.9×105±8.9×103 RLUs for Gluc and 2.2×107±7.1×105 RLUs for FFluc.

For the tactile task the maximum signal is reached at 78 seconds, almost directly after the end of the stimulation period.

For the 3-component systems of Fas/FADD/Caspase-8 and NLRP1ΔLRR/Asc/Caspase-1, the maximum signal was produced by cells grown with X-gal substrate, while the minimum was set by either cells grown without X-gal substrate (Figure 6) or by adding ZVAD-fmk (Figure S18).

The maximum signal was obtained after a reaction time of 30 min (not shown).