In Li+ solutions, cells exhibited slightly less shrinkage; this was still statistically significant shrinkage to 74 ± 3%, P < 0.001 and within 20 min of maximum shrinkage returned to 94 ± 2% of starting volume.
Whilst there is quite a lot of scatter in the data, it is evident from the trend lines that the maximum shrinkage corresponds to the loss of one H2O molecule per Si atom; the exact meaning of the full lines is explained in §6.
Hence, the dynamic nonlinear multivariable (i.e., time, temperature, stress) shrinkage exhibited by self-reinforced polypropylene (SRPP) tapes was measured and modeled at the maximum shrinkage limit achieved in the proximity of the composite processing temperature [∼140 °C]60 °C].
Maximum tumor shrinkage was defined as the percentage of change from baseline in the sum of tumor diameters of target lesions at the maximum shrinkage observed.
In AIJ (2003), to ensure the quality of drying shrinkage the maximum shrinkage should be smaller than 800 με.
In the absence of other additives, TMAC causes maximum shrinkage.
While coal ash 1 exhibited maximum shrinkage rate at 910°C, for coal ash 6 the maximum shrinkage rate occurred at 875°C.
The following parameter set of PlusTipTracker was used: maximum gap length, 12 frames; minimum track length, three frames; search radius range, 5 10 pixels; maximum forward angle, 30°; maximum backward angle, 10°; maximum shrinkage factor, 1.5; and fluctuation radius, one pixel.
Anisotropic Gaussian Detection method; Maximum Gap length 4 frames; Minimum length of Track Segments 3 frames; Brownian Search Radius 2 10 px (Multiplication Factor 3); Number of Frames for Nearest Neighbor Distance Calculation 5; Maximum forward angle 30°; Maximum backward angle 10°; Maximum shrinkage factor relative to growth speed 1.5; Fluctuation radius 1 px.
The fine aggregate content had the highest effect on both the maximum temperature rise and shrinkage of mortars.
