Sentence examples for maximum shear force from inspiring English sources
In addition, the maximum shear force is limited at serviceability limit states in order to avoid significant inelastic behaviour.
Failure test of the sensor shows that the sensor can withstand a maximum shear force of 67 N.
In each simulation, a non-linear dynamic analysis is performed to evaluate the maximum shear force, moment, shear strain, and curvature in the columns.
Under such conditions, the maximum shear force of 6.9 kN and an average shear strength of 47 MPa were achieved corresponding to a joint efficiency of 83%.
Conventional designs and finite element simulations showed significant reductions in computed horizontal deflection at the tip of the wall, structural demand in terms of maximum shear force and bending moment, and construction cost in terms of excavation and material when shredded tire was used as the backfill.
Upper and lower bound curves of maximum shear force and maximum bending moment in the stem were also produced based on the results of parametric studies conducted by varying the friction angle and cohesion of shredded tire, and the amplitude and mean period of the input motion.
The times that required to reach the maximum shear forces decreased to 177 ms and 149 ms, respectively, when PTZ was applied at 20 mmol/L and 40 mmol/L (Fig. 2C).
The purpose aims to improve the plate shearing section quality and metal yield by means of optimal blade clearance adjustment model of rolling-cut shear and accurate calculation of the maximum shearing force, as well as for the system optimization design, structure optimization design to provide important basis.
Optimization of process factors by grey relational analysis showed that applying US vibration and selections of 1200 RPM tool rotary speed, 6 mm plunge depth and 6 s dwell time causes the highest value of grey relational grade and guarantee maximum lap shear force as well as maximum hardness.
This loading profile induces a maximum calculated shear force of 346 N and a maximum compressive load of 750 N.
The BF475 test deformed the building to a maximum roof displacement equal to 0.6 m, while the maximum base shear force was 180 kN. Figure 21b shows the plot of the base shear versus roof displacement hysteretic curves for the BF975 test.
