Sentence examples for maximum separation of from inspiring English sources

BIM assists with providing maximum separation of waste types.

The optimum plate aspect ratios for maximum separation of heavy water, maximum production rate and minimum plate surface area in flat-plate thermal-diffusion column with plate surface area fixed, have been determined.

In the failed cell, the maximum separation of the electrode assemblies was measured in each direction (XY = 833 μm, YZ = 787 μm), representing a significant increase from the untested cell, where the spacing was below 43 μm.

Of primary interest is the maximum separation of the rings as a function of stress ratio to achieve a stable equilibrium solution and the corresponding radius at the mid-plane between the rings, termed the necking radius.

In fact, as for the transfer loop shown in Figure 2b, the maximum on/off ratio of 6.3 occurs at a Vg of -4.8 V, while the maximum separation of 0.11 mA between the ON and OFF state Ids values occurs at a Vg of -3.6 V.

Although there does not exist simultaneously the optimal angle of inclination and optimal plate spacing for maximum separation of heavy water from water isotope mixture in flat-plate thermal-diffusion columns, increasing either inclination angle or plate spacing will increase, respectively, the optimal plate spacing or optimal inclined angle, as well as the corresponding maximum separations.

They were able to replicate the proposed motion with their model, although they found that additional secondary movements between other bones were required, with maximum separations of 1.3-1.4 1.3-1.4een some bones during the cmewing cycle.

The bonding probability BP, between pairs of cells at a maximum separation distance of 5 μm (estimated to correspond to maximum length of lamellipodia extension) is then calculated: B P = (P 1 * P 2 ) (e s e p + 1 ) 1 3 The pair of cells will form an initial E-cadherin mediated contact if a pseudo-random number is less than BP.

Force curve data were collected as the mineral surface approached, made contact with, and subsequently separated from the cantilevers supporting immobilized cells at rates between 600 and 1000 nm s-1 (chosen to mimic typical swimming velocities of motile bacterial cells) starting at a maximum separation distance of 500 nm and at a frequency of 1 Hz.

A debarking efficiency of up to 95% and maximum separation efficiency of 75% were found from the evaluation.

A maximum separation factor of 1.53 with a corresponding flux of 4.4 g/m2 h are obtained at an optimal β-CD loading of 15 wt%.