Although the actual maximum sample volume was only 53 samples per day in our experience, modeling was thus able to quantitate the potential capacity by using standard prepandemic resources and processes.
At pH 8 the change from deionized water to hard water doubles the maximum adsorption capacity of sample CP (101.7 mg g−1 vs 211.9 mg g−1, respectively).
For all samples, the maximum discharge capacity was reached at the first cycle, then slightly decreases for next cycles to remain stable at higher cycle number.
The same TAPP porphyrin was tested for the retention of copper from synthetic copper samples with a maximum adsorption capacity of 280 mg/g.
Due to its chelating nature, the same porphyrin was also tested for the retention of copper from synthetic copper samples, showing a maximum adsorption capacity of 280 mg/g.
The materials with different layered-spinel phase ratios prepared in different gradient calcination processes show apparently different electrochemical performances, e.g., the maximum discharge capacity of the sample reaches 297 mAh/g at 0.1 C, it even exhibits high capacity retention of 90.6% after 200 cycles at 0.5 C.
As a sub-study of a secondary outcome, sample size was determined by the maximum processing capacity of our laboratory and logistical feasibility of data collection; no power and sample size calculations were performed.
Thus, for a wideband speech signal sampled at 16 kHz, the maximum payload capacity would be 200 (=16000/(22 × 20)) bits per second (bps).
As the maximum memory capacity of the exposimeter is 12 540 sampling intervals and the study will last for 120 h, the exposimeter will measure at an interval of 36 s.
In general, air-gasification produces lower regeneration properties, although direct air-gasification sample has 87% recovery of the PNP maximum adsorption capacity.
