Sentence examples for maximum rubber from inspiring English sources

The maximum rubber replacement in the same mix can be limited to 7.5% to maintain the increase in sorption rate below 15%.

The newly derived design rules showed that shear strength is critical compared to the combined moment and axial thrust and the maximum rubber contents were 17% and 30% for normal and high strength concretes, respectively.

Furthermore, it can be concluded that the electro-cleaning roughness of Rz ~ 17.5 μm and average roughness of Ra ~ 2.52 μm of steel wire surface would provide the maximum steel-rubber adhesion strength.

Pull-out test results confirmed that an optimum electro-cleaning current density of 600 A/m2 is required to obtain the maximum steel-rubber adhesion strength of 141 N compared to the base sample (120 N with no electro-cleaning).

When flat spacing is twice larger than the maximum diameter of rubber cement and the size of the added grain is not more than 0.250 mm, the DSR can be used to test rubber paste properties [12, 13, 14].

At maximum tension, the rubber band should fire about 15 to 20 yards (13.7 to 18.3 m).

The magnetic flux density indicates a mountain like profile between the magnets, having a maximum for the neodymium rubber and metal magnets.

Under the action of drilling fluid pressure, the maximum effective stress of rubber lining appears in the bottom of arc, and the minimum stress appears at the top of arc.

The low-profile tires felt surprisingly good, with none of the ride harshness usually found in rubber designed for maximum performance.

Tensile strength depends not only on the crosslink density but also on the amount and size of strain-induced crystals [18] present in maximum elongated state of the rubber vulcanizates.

Quantitative 13C NMR measurements indicated that strain-induced crystallization occurs when the draw ratio reaches about 2.0 and the maximum crystallinity of our natural rubber samples can be as high as 19.3% upon stretching.