Sentence examples for maximum relaxation from inspiring English sources
When 20% (v/v) DMSO was used, the maximum relaxation efficiency can be obtained, where 92% of supercoiled pBR322 was relaxed (Lane 6 in Figure 1(c)) while the ratio of relaxed plasmid is only 23% when no DMSO is added (Lane 2 in Figure 1(c)).
Leonard equals maximum relaxation".
The magnitude of maximum relaxation, however, was not affected.
Endothelium-dependent maximum relaxation (Rmax) in the arterial segments induced by acetylcholine was significantly decreased in both hypertensive patients and SHR.
A maximum relaxation time and thus a maximum micellar stability was found at 200 mM SDS, corresponding to the least foaming, largest bubble size, longest wetting time of textile, largest emulsion droplet size and the most rapid solubilization of oil.
Maximum relaxation responses of aortic and pulmonary artery rings were decreased in the MCT-vehicle group (54.80±5.69 and 35.87±4.78, respectively) compared to the control (91.51±4.79 and 54.32±2.39, respectively) but improved with LASSBio-965 treatment (50 mg/kg; 88.43±4.54 and 59.36±4.83, respectively).
The calculated means EC50 (95%% confidence limits) and maximum relaxations for this effect were: 1 × 10-4 μg/ml.
For PVPh, a maximum in relaxation times is observed around 30 wt% PEO.
(b) Assuming the maximum contribution of relaxation to the total loss, for the W3 sample, the contribution of relaxation to the total SAR is 0.16% and the remaining SAR belongs to the hysteresis (99.84%), and for the W4 sample, the corresponding values are 0.76% and 99.24%, respectively, indicating that hysteresis is a more effective mechanism in producing of heat.
This relaxation maximum is tentatively ascribed to the motion of grain boundaries or dislocations, which are pinned by precipitates in γ-TiAl.
Extruded single-phase γ-TiAl with an aluminium content of 54.1 at.% shows a large, frequency-dependent relaxation maximum near 1300 K during cooling from temperatures above 1400 K, which is neither observed during heating from ambient temperature nor in two-phase α2/γ-TiAl alloys with a lower Al content.
