Sentence examples for maximum relative intensity from inspiring English sources
The 2θ values for all of treated fabrics are similar; 'p' and p c blended fabrics show the maximum relative intensity.
Its integrated intensity increases approximately linearly with increasing temperature to a maximum relative intensity of few percent relative to the 5200 cm−1 intensity (Fig. 3).
The lasers linewidth should be in the order of tens of Hz, with a maximum relative intensity noise (RIN) of -107 dB/Hz and a minimum optical power of 0.94 mW.
In photochemical reactor, reaction mixture of 50 mL was taken and irradiated with LEDs (UVLEDs) trip peak having 6 W output power and maximum relative intensity of wavelength of 375 nm for each LED, totally 5 sets of photocatalytic reactors, each reactor having 20 LEDs [27, 28] and solar light.
The resulting data for the three gels (same set as in Figs. 2- 4) of differing Col V concentration are shown in Fig. 6, where they are scaled relative to the maximum relative intensity at the same laser excitation power.
(H ) Maximum relative intensity changes (max ΔF/F0) of synapsin-ECFP, and CAPS-1 at synapses and CAPS-1 at extra synaptic regions at t=160 s calculated from G (**p<0.01, n=5 cells each).
By varying the pH from 5.5 to 8.5, it was found that the maximum relative fluorescence intensity (F 0/F) appeared at 7.0, where F0 was the fluorescence intensity of the QDs without quencher and F was the intensity with the quencher at a certain concentration.
The maximum relative fluorescence intensity was seen with αA-wt whereas αA 1 172 had lower fluorescence intensity, αA1 168 showed further decrease in the fluorescence intensity, and αA1 162 showed the lowest.
In the region of VTHF<0.7, the emission maximum λem, relative intensity RF of ADDan60 in DMSO/THF to that in DMSO, and anisotropy ratio r indicated that the polymer maintained its solvation layer not to change so much as the bulk solvent and exhibited a polyelectrolyte behavior, as observed from ηsp/c and κ.
In addition, the number of intensity maximum, focal depth, focal shift, full-width half-maximum, and relative intensity of side lobe are listed for different radii of the phase zones, which paves the way for design of the phase plate.
For the control treatment, the fluorescence maxima and relative intensities of the precipitated fractions were nearly identical to those observed for the whole HA samples.
