As the maximum reference values for height of the Hong Kong official weight-for-height (WFH) cutoffs were 175 cm in boys and 165 cm in girls [ 41], students who exceeded these height limits were excluded (n = 738).
The overall HPV vaccination quality scores were 73.07%, 71.08%, and 67.21% for ASL1, ASL2, and ASL3, respectively, and the overall minimum and maximum reference values were 20.82% and 86.10%.
Comparison of total TEM data to maximum reference values reported in the literature indicated that weight was the only measurement for which our results remained below the maximum acceptable TEM on both study occasions; height was only acceptable in study B. Total TEMs for all other measurements were above the suggested maximum acceptable total TEM[ 26].
Serum insulin was measured by a two-site chemiluminescent immunometric assay (Immulite 2000; Diagnostics Product Corporation, now part of Siemens, Los Angeles, CA, USA) with a minimum detection level of 35 pmol/L and a maximum fasting reference value of 180 pmol/L.
Also, the R value [(maximum ALT/upper limit of reference value of ALT for the illness) ÷ (maximum ALP/upper limit of reference value of ALP for the same period)] of 9.0 was lower than that of the five typical episodes (12.8 27.2).
Maximum changes around the reference value are 2.1% and it is equivalent to 0.027 kW which represents good disturbance rejection in areas in the matching model.
SBML-SAT samples the parameters using Latin Hypercube sampling (LHS) [ 22, 25], where 2000 equidistant samples from the minimum to the maximum (0.1-10 thees the reference value) were drawn, for each parameter subjected to the perturbations.
The results also show that using the proposed valve lift controller, the maximum lift deviation from its reference value does not exceed 0.4 mm during transient operating condition.
A second empirical diagnosis function is defined to compare methane flow rate measurements against a reference value of maximum capacity (outputs between (0,1]).
For the BSS, the percentage of normal LOS in the AP direction is calculated by dividing the subject's AP stability index (maximum 20°) by a normal reference value of 12° and multiplying that number by 100.
