Sentence examples for maximum pullout resistance from inspiring English sources

The correlation between the physical properties of clinker ash and the maximum pullout resistance was investigated on the basis of the test results.

For the clay sand geogrid samples an optimum sand layer thickness of 10 mm was determined, resulting in maximum pullout resistance which increased with increasing confining pressure.

Also, the maximum tension force in each layer of reinforcement at the peak pullout resistance was checked not to exceed its yield point.

Overall, both types of fibres showed extremely similar pullout behaviour but difference in maximum pullout load and pullout work (Figs. 6, 7).

Results revealed that encapsulating geogrids in thin layers of sand under pullout conditions enhances pullout resistance of reinforced clay.

Model validation is performed by comparing the calculated pullout resistance with experimental data.

This indicates that the pullout behaviour is drastically governed by the hook component and increasing in embedment length does not have significant contribution to the maximum pullout load.

It seems that the maximum pullout load significantly influenced by the plastic deformation of the fibre hook and increase the embedded length only enhances the frictional pullout stage.

It is apparent that the increase of embedment length has no great effect on the maximum pullout load but it relatively increases the total pullout work.

The maximum pullout load and the total pullout work (the area under the pullout curve) of both types of hooked end fibres increase as the W/B ratio decreases (Table 4).

It can also be seen from the curves that decreasing W/B ratio from 0.25 to 0.15 remarkably enhances the maximum pullout load and pullout work.