Sentence examples for maximum product concentration from inspiring English sources
The maximum product concentration of a molecular compound at the feed point in reaction crystallization is analysed by modelling.
The maximum product concentration is constant in time but varies with diffusivities and reactant concentrations in a quite complicated fashion.
Under certain conditions the maximum product concentration may even decrease when initial reactant concentrations or reactant diffusivities are increased.
A solvent screening criterion was developed based on the maximum product concentration attainable for the assessment of batch and semicontinuous multicomponent extractive fermentations.
The maximum product concentration is taken as a first estimate of the maximum supersaturation and is used as a basis to discuss the product crystal size that may be produced.
Particularly, for cases of an elliptical inclusion with intermediate hydraulic-conductivity contrasts, where the travel-time distribution shows bimodal behavior, the prediction of both the BTCs and maximum product concentration is significantly improved.
The optimum substrate concentration to be employed for obtaining maximum product concentrations was done by adding different substrate concentrations to P. aeruginosa cell growth.
The maximum volumetric product concentration achieved at this dilution rate was 474 mg l−1, which translated a ∼1.4 and ∼1.75 folds increase than the values obtained at dilution rates of 0.2 h−1 and 0.4 h−1 respectively.
The results showed that the use of a larger particle size caused the productivity to be limited by the constraint on X2 product concentration, and a maximum productivity was attained by choosing the particle size such that the effect of the X2-concentration limiting factor could be balanced with that of pressure-drop limiting factor.
When βF24G was used for ampicillin synthesis under kinetic control at industrially relevant conditions, 95% of nucleophile 6-aminopenicillanic acid (6-APA) was converted to ampicillin in aqueous medium at room temperature while 12% process time is needed to reach maximum product accumulation at 25% enzyme concentration compared with the wild-type Af PGA.
However, in the diatom Phaeodactylum tricornutum, maximum product yield and maximum biomass concentration were achieved at the same cultivation temperature between 21.5 and 23 °C.
