Sentence examples for maximum pressurization from inspiring English sources
Pressurization is induced near the conduit below the PCB, and maximum pressurization occurs just beneath the PCB.
To prevent this, we need to ensure the glenoid vault is not perforated during insertion of the glenoid implant to allow for cement containment and maximum pressurization.
These configurations contain regions with stress levels far higher than those predicted for the cyclically symmetric design configuration under maximum pressurization.
When obstruction is not introduced (e.g., only increase in the hydrothermal flux is imposed), the maximum pressurization occurs just above the water table in the vicinity of the conduit.
The maximum pressurization rate is also measured for this Al/Bi2O3 mixture (∼5762 kPa/μs) at 30% TMD comparatively higher than the others: 172, 35 and 33 kPa/μs for Al/CuO, Al/MoO3 and Al/PTFE respectively.
Although the stoichiometric ratio for the thermite reaction between Al and CuO is 2 3, our experiments show that the maximum pressurization rate occurs in Al-rich thermite composites.
The pressure time characteristics indicate higher maximum pressure and pressurization rate for Al CuO/CL-20 becAl CuO/CL-20ssure loss at microscale is well compensated becauseaddithen of fine CL-20.
This study presents experimental and simulated data obtained from a bench-scale PSA, with a maximum pressure of 6 bar for pressurization and feed steps and minimum of 1 bar for blowdown and purge steps.
The color scale represents the maximum amplitude of pressurization in the shallow part of the edifice over the simulated 10-year period.
We also evaluated the possibility of inactivating cells with the lower pressure than 200 MPa by using distilled water that was hyposmotic and could inactivate cells easily compared to the NSS or using a longer pressurization time with a maximum of 60 min.
In this work, an artificial neural network (ANN) is used to predict two parameters of interest for high-pressure food processing: the maximum or minimum temperature reached in the sample after pressurization and the time needed for thermal re-equilibration in the high-pressure system.
