Sentence examples for maximum pressure head from inspiring English sources

A maximum pressure head of 0.96 with a total pressure head difference of 1.76 and maximum flow rate of 1.27.

This critical length was found to be a function of the sand porosity, cycle period and maximum pressure head.

A maximum pressure head of 0.8 was obtained giving a total pressure head difference of 1.6; this indicates an improvement of 33.3% on the achievable pressure head difference.

The flow rate is then gradually decreases to −0.64 with very small gradient and stops at the maximum pressure head of −0.8.

The maximum pressure head of ±0.8 is shown where the flow rate reaches zero reading, giving a total pressure head of 1.6.

Various maximum pressure heads (0.25, 0.3, 0.35, and 0.4 m), periods of cyclic wave loading (6, 7, 8, and 10 s) and particle porosities (34%, 35 %, 40, and 45%) were used in this test series.

Results indicated that preferential transport of dye and microspheres via macropores occurred when maximum pressure heads were greater than − 3.0 cm, and the corresponding infiltration rates exceeded 2.0 cm h− 1.

As shown in Fig. 6, maximum incremental pressure head was observed to be 1.12, giving a total pressure head difference between the first and last reservoir of 1.92.

Infiltration was conducted under maximum infiltration pressure heads ranging from − 5.2 to − 0.4 cm.

Continental glaciological modelling of the Laurentide ice sheet through the last glacial cycle lasting approximately 100,000 years suggests that this site was glaciated at about 60 ka and between about 22.5 and 11 ka before present with maximum ice sheet thickness reaching 2500 m and maximum basal water pressure head reaching 2000 m.

Looking into Q 4, high positive flow rate is observed to reach a maximum of 2.1 at pressure head of 0.16.