Sentence examples for maximum power when from inspiring English sources

As observed, it reaches the maximum power when the wind speed is 12 m/s.

where ( {P}_{hp}^{min} ) and ( {P}_{hp}^{max} ) are the allowed minimum and maximum power when the heat pump is turned on.

In order to maximize the exploited wind power and benefit from a wide range of the wind speed, a novel combined maximum power point tracking (MPPT -Pitch angle control is developed using only one low cost circuit based on Neural Network (ANN), which allows the PMPPT -Pitchanglet an optimal speed to extracontrolmum power when this last is lower than nominal power, andevelopedhe extra power.

For example, in our simulated data set of 10,000 participants, a realistic sample size for large-scale genetic association studies, obtaining exposure data for approximately 20% of the full sample achieves maximum power when the first-stage R is greater than 0.015.

The team calculated that Bolt's maximum power occurred when he was less than one second into the race and was only at half his maximum speed.

In the experimental study, cell performances revealed maximum power density when current collectors were located at the high flow rate region.

We can include that in first time the PID controller could not control the pith angle for use of maximum power electric when wind speed is increased.

The subsequent electrochemical measurements of the fuel cells with various cathodes reveal that the addition of DSO in the cathode catalyst layer can effectively prevent the cathode flooding at high current density, thus leading to a much higher limiting current density and the maximum power density when compared to the fuel cell with a normal cathode.

However, power increased much more rapidly in Table 2, which corresponds to a situation of complete congruence, with maximum power obtained when three or more CM were included in a replicate, regardless of matrix sizes (n).

For some mixtures we find the maximum net power when the temperature glide of condensation matches the temperature increase of the cooling water, while for other mixtures there are large differences between these two parameters.

In Case D (Fig. 6a), the reservoir keeps and saves water when power requirement is low (stages 1 4), and the hydropower plant generates at maximum power in periods when demand requirements and thermal costs are higher (stages 6, 7, 11 and 12).