Sentence examples for maximum power ratio from inspiring English sources

A maximum power ratio of 2.67 was observed when comparing the electrical output of the concentrator unit with a non-concentrating counterpart.

The indoor characterisation of the concentrating photovoltaic (CPV) module results in a maximum power ratio of 2.27 when compared to a similar non-concentrating counterpart, for 1000 W/m2 light energy incident at 20°.

The summed ERSPs were exponentiated to convert them to power ratios and then normalized by dividing by the maximum power ratio across the six noise conditions.

Table 2 demonstrates that most subjects displayed an SR effect, in that the maximum power ratio in the 40-Hz response window (0 100 ms after onset of a standard) occurred for a non-zero noise level.

Carburetor design is further complicated by the need for an enriching device to provide a maximum-power ratio at full throttle, a choke to facilitate starting a cold engine, an idling system to provide the special needs of light-load operation, and an accelerating device to supply additional fuel while the throttle is being opened.

The exception is the L SFG, which displays a maximum normalized power ratio for left standards at -5 dB of added noise whereas the R STG displays a maximum at 0 dB for the same stimuli.

Initial experiments showed a maximum PR (power ratio) of 2.2 compared to a non concentrating counterpart.

A maximum net electrical power ratio between charging and discharging of 125% is obtained, while the maximum exergetic efficiency is 59%.

Form the experiment results, the ALCPC increases the maximum power by a ratio of 1.74x compared to the bare cell.

Given the above discussion, one might also reasonably expect that primary sensory areas such as STG would display a maximum in the power ratio at a lower noise level than would areas more removed from the noise input, e.g., SFG and PCi.

In order to analyze the influence of buffer size, the buffer-power ratio (ratio of maximum power of buffer and generator) is varied, while the overall power-to-weight ratio of the vehicle is held constant.