Sentence examples for maximum power performance from inspiring English sources

The obtained results are compared with those of the maximum power performance criterion.

This paper uses this method to illustrate the influence that wiring can have on the direct current operating voltage that is needed at the power inverter to achieve maximum power performance for the system.

Table 2 Car specifications for a conventional automobile ((ADVISOR) AVS (2002) Parameter Nominal value Maximum power: low performance 50 hp Maximum power: high performance 150 hp Mass: low performance 848 kg Mass: high performance 1,187 kg Gearbox Manual Nominal gear ratios  Gear 1*Gear_diff 13.45  Gear 2*Gear_diff 7.57  Gear 3*Gear_diff 5.01  Gear 4*Gear_diff 3.77  Gear 5*Gear_diff 2.83.

The piezoelectric transducer accomplished maximum power response performance at the 96 dB and 33.133 dB (uW).

In addition, our TFC membranes were able to capture 65 81% of theoretical maximum power density performances in comparison to only 50% of the more compactable commercial FO membrane.

More recently, Gholaminezhad et al. [20] applied a multi-objective optimization and uncertainty analysis of methane fed SOFCs for maximum power density and efficiency performance achievement.

Both simulation results and experimental tests on a real PV system show that the FLC provides good tracking for the maximum power point (MPP .Finally, the performance of the FLC on a real PV system consisting of a commercial solar panels Atersa model A55 is analyzed.

To achieve maximum efficiency in terms of power, performance, and reliability in dynamic scaling of voltage and frequency, it is critical to have a simple and accurate reliability model which estimates the value of fault rate considering supply voltage and operating frequency of a circuit.

Therefore, the performance of maximum power point tracking (MPPT) element in PV system under dynamic environmental conditions is very crucial.

Likewise, increasing the maximum power rating of the higher performance rolling stock above that of the existing Metrocars will also alter this trade-off.

Different designs of W monoblock mock-ups as well as a W macrobrush mock-up showed very good performance at maximum power densities between 14 and 20 MW/m2 (absorbed).