Sentence examples for maximum possible surface from inspiring English sources

This upper limit is still several times higher than the maximum possible surface pressure of the carbon dioxide, meaning that the measurements place essentially no constraints on parameters of the atmosphere.

In simulated compression type A fractures with posterior stabilization (using an internal fixator), an impaction of 1 mm-oversized block grafts provided graft compression and a contact area that represented 75% of the maximum possible surface on the wooden dowels.

The maximum possible subsidence at surface point x p for an inclined coal seam is determined by Eq. (16).

Note that, because there exists no direct evidence regarding the actual depth and geometry of the plate interface, the iso-depth contours represent the maximum possible depth of the slab surface, which might be a few to ∼10 km beneath the upper surface of the subducting Indian Plate.

The hydrated ionic radius of the cation (counterions) determine its maximum possible concentration at the charged surface; therefore, it has an influence on the diffuse double layer spatial distribution [28].

For O2, its modest solubility in water reduces the maximum possible concentration at the plant surface to 0.25 mol m−3, well below the 8.31 mol m−3 present in free air (at 25 °C).

As the bar was free to move upwards in the vertical direction, the maximum possible downward force over the entire surface due to the mass of the bar was equal to 1 N.

Thus, as shown in Figure 6 C i), at 50 50 MPS PT surface coverage the ZnTMPyP will cover only approximately 50% of the surface (and give half the maximum possible signal) since the PT-covered half will not allow ZnTMPyP binding.

When W is less than 1 μm (it is relevant in the light of the discussed problem), the short-circuit current density is much lower than the maximum possible value 23.2 mA/cm2 even in the absence of surface recombination.

Since Δ Cpconf cannot exceed the value of Δ Cp (because this would require the binding surface area to be negative), the maximum possible value of Δ Cpconf is –0.6kcal/mol.

In the absence of surface diffusion, increasing the positive feedback gain increased the maximum possible polarization among the multiple steady-state solutions.