Sentence examples for maximum possible errors from inspiring English sources

2) The discussion of the maximum possible errors in R0 is extensive, but mainly concerns the experimental FRET aspects of the problem.

Nonetheless, we calculated the maximum possible errors in R0 due to anisotropic orientation of the dyes (Table 2; Figure 5B, Figure 5 figure supplement 1); the actual errors in R0 should be much smaller.

The mid-point method was better at predicting peak offence times than the start or end methods, possibly because the maximum possible error of the mid-point method is half that of the other two deterministic methods.

By theoretical analysis, the correlation integral time and its maximum possible error are determined.

Although errors may cancel, we must calculate the maximum possible error assuming that errors are additive [8, 9].

Therefore, the maximum possible error on the polarization ratio induced by the noise is less than 0.1.

First convert absolute errors to % errors, The maximum possible error is determined by adding the % errors together, If a reading is raised to a power in a calculation, then the % error for that part is the power times the % error.

The model results are validated through a comparison with published experimental data and found to be in a good agreement with a maximum possible error value of 10.3% in cell potential and power density output.

The maximum possible error resulting from this asymptotic modelling can be determined by using positive and negative stiffness values, or in general terms using positive and negative penalty functions.

Derived by using this approach, the upper and lower transient approximate solutions are not just useful in analyzing the range of the maximum possible error between them and the analytic solutions correctly, and the numerical validations also indicate good accuracy in mean values of the upper and lower approximate solutions.

Together with the upper bound results from the SM, the maximum possible error in the first 12 non-zero natural frequency parameters for completely free rectangular plates of various aspects ratios ranging from 1 1 to 3 1 can be determined from the results presented here.