Sentence examples for maximum photocurrent densities from inspiring English sources

Furthermore, as shown in Figure 6, the maximum photocurrent densities were about 1.1, 3.6, and 1.8 mA/cm2 for AZO(H -CdS (1), AZO(H -CdS (3), and AZO(H)-CdS (5), respectively.

Under simulated solar illumination, the maximum photocurrent densities of the TNTAs/QDs with 10 cycles ZnO, 25 cycles TiO2, and 30 cycles Al2O3 overlayers are 5.0, 4.3, and 5.6 matcm2 at 1.0 V (vs. SCE), respectively.

Photo-electrochemical, morphological and optical properties were determined to explain the shift in photocurrent densities to lower electrode potentials and the decrease of maximum photocurrent densities for alkaline water oxidation after annealing.

The best photoelectrochemical performance with the maximum photocurrent densities of above 25 μA cm−2 and conversion efficiency of about 30% was observed for sample annealed at 500 °C.

The maximum photocurrent density of 500 µatcm2 (at 0.5 V vs. SCE) was obtained for α-Fe2O30.5 α-Fe2O30.5electrode.

The maximum photocurrent density and incident photon conversion efficiencies (IPCE) were obtained for 16 at.% Cr-doped films.

In this paper, we simulate front surface inverted pyramidal grating texture on 2 400-μm 2 400-μmlicon and opthicke it to derive maximum photocurrent densiliconom the cell.

A maximum photocurrent density of composite photoanode is achieved with a deposition time of 3 min, which is higher than that of pristine WO3 photoanode around 40%.

A maximum photocurrent density of 2 mA cm−2 is achieved for the ZnIn2S4 nanowiret/TiO2 nanowire composite film for a 6 h reaction time under white illumination.

Figure 4 shows that H-TiO2 nanorods exhibit a significant change in PEC performance with a maximum photocurrent density after hydrogen treatment at 400 °C.

Combining the magnetic action and the photovoltaic effect, the titanium dioxide photosensitive anode showed a maximum photocurrent density of 296.05 matm2 at 2 V bias.