Sentence examples for maximum peak stress from inspiring English sources

A very good comparison has been observed for the applied maximum peak stress range of 925 975 MPa.

The results for prestrained specimens revealed that fatigue life was almost the same in the same strain range regardless of stress amplitude, maximum peak stress and mean strain.

In fatigue design, the consideration of effective stress as the maximum (peak) stress often produces over-conservative predictions, particularly when dealing with inhomogeneous stress distributions.

However, if temperature-dependent material properties are used in a detailed FEM, there is a maximum peak stress discrepancy between a conventional GFA and a detailed FEM because constant material properties are used in a conventional method.

Once stress-strain curves were obtained and AE data are processed, we calculated the static elastic moduli for each specimen utilizing Equations 6 and 7 with the tangent deformation modulus at 50%% of the maximum peak stress (Ulusay and Hudson [2007]).

For tetanic contractions, time of activation (TA) was defined as the time from 10 90% of maximum peak isometric stress, and time of relaxation (TR) was the time from 90 10% of peak isometric stress.

After exceeding the compressive peak stress (maximum loading limit), the honeycombs underwent either a continuous post-buckling mode with a folding collapse (lower relative density) or a symmetric extensional collapse mode of the entire frame (high relative density).

A lower hydrogen concentration also leads to the synthesis of CNT arrays that can reach higher peak stress at maximum compressive strain, and dissipate a larger amount of energy during compression.

Compared with the tested peak stress and simulated maximum stress of A-type frame under full loadings, the difference is acceptable so that the accuracy of finite element model of A-type frame is guaranteed.

Figure 4a shows that at the beginning of the test, the shear stress increased with the shear relative displacement to a maximum value and then remained constant (no peak stress).

However, the peak von Mises stress, the peak maximum principal stress and peak shear stress in the cement mantle at the bone-cement interface for the 43 mm diameter cup design were predicted to be lower compared to those for the 40 mm diameter cup design.