In the same way, because a slight failure of the coil compensation contributes to greater reduction of the SNR, we found that the maximum peak of a pulse was set to 0.7 T in this study.
The effect of this operating variable was studied over the range 10-100 mV (Figure 7) and it was concluded that in order to assure maximum peak current, 70 mV pulse amplitude is the ideal choice for this operational parameter.
During the RF pulse, the maximum peak voltage, forward/reflected powers, temperature on the antenna and gas pressure are measured.
Q-switched pulses with maximum peak power of ≈10.4 kW, with energy of ≈0.5 mJ/pulse, were extracted with 30% extraction efficiency.
The amplitude of peak current INa during the test pulse was normalized to the maximum peak current INa,max and plotted against the prepulse potential.
A core consequence of the result is that, when the disturbance pulse response peaks faster than the input pulse response, then attempts to minimise the maximum peak response to the disturbance are necessarily accompanied by unavoidable undershoot at a later time.
In the investigation of differential pulse stripping voltammetric behavior of drugs, maximum peak current was observed for AMLD, FELD, and NIMD at 30, 20, and 10 s respectively.
There was no statistically significant difference in the length of the initial phase, nadir SpO2, fall in SpO2, peak pulse rate, rise in pulse rate, and maximum oxygen supplementation given between the groups.
The maximum laser power at the objective lens was 4.1 W (i.e. 41μJ per pulse and a peak pulse power of ~0.1GW).
The maximum peak error is 4.7%.
