Sentence examples for maximum peak for from inspiring English sources

The 2PA maximum peak for compound 15 appeared at 890 nm with a value of 33,000 GM.

The maximum peak for pyrene in water was about 335 nm; the peak shifted to 337 nm in the solution of copolymer.

Adequate separation of the two peaks as well as the maximum peak for both drugs was between 270 280 nm; therefore, the channel was set at λ = 278 nm for analysis.

It reports five-minute averages maximum peaks for dry log wood of 30,000 105,000 OU m−3 in wood smoke, with accompanying very high CO emissions of around 4% v/v., indicating prevalence of smoldering combustion conditions.

The resulting gfp uv is expressed two to three times faster in E. coli strains and shows 18 times brighter fluorescence than the native gfp; the maximum peaks for fluorophore excitation being at 395 nm and centered at 508 509 nm for emission [ 1].

The presence of the phosphomutant GFP-ERS118E induces a maximum peak of transcript levels for EGF at 15 minutes (p>0.05) (Figure 7B).

By assuming that every STA transmits (or receives) its individual traffic in same data rate within the nAP's range, is the busy ratio for the maximum peak of, where.

Critical conditions for the maximum peak responses for one- and two-dimensionalfinite periodic structures are discussed.

The difference between groups for the mean maximum peak value for Yaw movement angular velocity was 86.48°/s (P < 0.05) (see Table 3).

While the healing efficiency is strongly dependent on the type of epoxy material, the average maximum peak load for fracture after healing is roughly the same for all tested epoxy materials.

The maximum peak temperature for the double-layer repository is slightly higher than that for the single-layer repository, but remains below the temperature limit.