Sentence examples for maximum peak between from inspiring English sources

Both ED and SDPS plots can detect the predominant transients of each signal by the position of the maximum peak between d1 and d6 crystals and thereby may categorize several corroding systems according to the pit size.

The PL maximum peak is located at 421 nm, and its spectral width extends from 400 to 542 nm; also, it is observed in the spectrum that a secondary PL peak of low intensity is in the near-infrared range with a maximum at 820 nm as we can see in the inset of Figure 3a.The PL spectrum of the M-10 solution presents three peaks showing a PL maximum peak between green and violet.

Among tissue-specific motifs, MZF1 was significant in cortex, hindbrain and midbrain (maximum peak between -39 to -44, p-value <= 10-3); AP2 in brain, cortex, hindbrain and striatum (maximum peak between -50 and -58, p-value <= 10-3 in the three latter tissues); and EGR in striatum (maximum peak at -81, p-value = 6.08 × 10-4).

For H-component, the maximum peak falling between 11 and 12 LT is considered as NQDs and if it falls outside this range or it shows two peaks instead of one peak are termed as AQDs.

The PSi samples showed intense near-infrared PL spectra under UV excitation; all samples have a Gaussian-like shape with the maximum peak located between 743 and 966 nm, depending on the sample, as shown in Figure 1. Figure 1 PL spectra of the PSi samples prepared with different etching current densities.

Correlation between average roughness (Ra) parameters and the ratio between maximum peak height and average distance between the highest peak and lowest valley (Rp/Rz) and wettability for the different treatment conditions were analyzed.

By adding these additional criteria, energy storage planning is optimized seeking to minimize the following: total Microgrid (MG) costs; PEVs batteries usage; maximum peak load; difference between extreme scenarios and two Sharpe Ratio indices.

However, if temperature-dependent material properties are used in a detailed FEM, there is a maximum peak stress discrepancy between a conventional GFA and a detailed FEM because constant material properties are used in a conventional method.

Animals were sacrificed 14 days after immunization, which is the time point of maximum infiltration of CD8+ T cells in the brain parenchyma and the maximum peak of interaction between virally infected cells and T cells [10].

Maximum peak values agreed well between manual samples and the detector with a mean difference of −0.4% ± 7.0% (max 12.0%, min −9.9%).

Afterwards, two simple tuning rules are derived to obtain undershoot-free responses based only a desired settling time or by satisfying a tradeoff between maximum peak and settling time specifications.