Sentence examples for maximum optical efficiency from inspiring English sources

The present study revealed that the maximum optical efficiency that can be reached in Dhahran is 73.5%, whereas the minimum optical efficiency is 61%.

The maximum experimental optical efficiency of the CPV system is found to be 80.5%; this result gives the electrical conversion efficiency of the CPV module to be an average of 9.43% with a maximum 12.1% within the range of acceptance angle of the designed concentrator.

Maximum optical slope efficiencies of 20.5% and 5.4% were measured in long-pulse and Q-switched operation, respectively.

The results prove that the maximum of the optical efficiency is achieved for 20 × geometric concentration ratio and 80°-rim angle.

The most widely used methods for heliostat field optimization assume a particular pattern and then optimize the parameters that define the pattern to obtain a specified objective such as optimum optical efficiency or maximum power output.

The total flux, the optical efficiency, and the minimum, maximum, and mean irradiances are evaluated for various ray sources using ray-tracing simulations of the ASTM G173-03 spectrum.

The results show that maximum relative error of 20% for the optical efficiency may produce if the refractive surface error transfer process is ignored.

Adopting this design, the maximum laser power of 468 W with optical to optical efficiency of 33% in CW mode and M2 factor of less than 15 is obtained.

Coloration efficiency of the polymer film is 23.77 cm2 C−1, meanwhile maximum optical contrast of the polymer film reaches to 40% at the wavelength of 658 nm.

The Mo-doped films showed maximum optical transmittances in the visible range from 35to45%5% and decreased IR modulation efficiency from 36 to 25% with increasing substitutional Mo content from 3 to 11%.

Compared to the previous works in Ref [9 11], the maximum optical power of our design is not remarkable because of the low wall-plug efficiency of the device.