Sentence examples for maximum normal cutting from inspiring English sources

Single layer electroplated CBN tools produced G-ratios and maximum normal cutting forces of ∼451 and ∼45 N, respectively, compared to ∼128 and 557 N for equivalent diamond wheels.

The specific sawing energy decreased with the increase of the maximum undeformed chip thickness in both the sawing conditions; however ultrasonic vibration changed the trend of specific sawing energy in normal cutting mode from exponentially decreasing to a good linear decreasing.

We find that as the cutting depth decreases, the tangential cutting force decreases faster than the normal cutting force.

Figure 8shows the time-averaged tangential and normal cutting forces during the cutting process for the different cutting depths.

However, the tangential cutting force decreases faster than the normal cutting force.

It is found that as the cutting depth decreases, both the tangential and normal cutting forces decreases; however, the tangential cutting force decreases faster than the normal cutting force.

This is because at this very small cutting depth, the normal cutting force is higher than the tangential cutting force, and therefore the normal cutting force undergoes stronger fluctuation.

It can be seen that both tangential and normal cutting forces decrease as the cutting depth decreases.

It can be seen that both the tangential cutting force,Fx, and the normal cutting force,Fz, increase at the start of the cutting.

It is also observed from Fig. 6that the normal cutting force,Fz, shows stronger fluctuation than the tangential cutting force,Fx.

With a larger cutting depth as discussed in next section, the magnitude of normal cutting force is close to that of the tangential cutting force, and so magnitude of the force fluctuations is also close.