Sentence examples for maximum nominal power from inspiring English sources

The optimum values for the different variables studied in each method were: 90 psi pressure, 475 W power and 4 min irradiation time (CMWD); 150 °C temperature and 4 min irradiation time (OMWD); 90% of maximum nominal power (180 W), 0.9 s (s−1) cycles and 1 min irradiation time (USD).

Microwave (MW) and ultrasound-assisted COD determination methods have been optimized by means of experimental design and the optimum conditions are: 40 psi pressure, 855 W power and 1 min irradiation time; and 90% of maximum nominal power (180 W), 0.9 s (s−1) cycles and 1 min irradiation time for microwaves and ultrasound, respectively.

The charging efficiency of the system is studied in two distinct engine operating states, conforming to maximum torque and nominal power conditions.

Unlike [23], the optimized parameters are the nominal power and the maximum cell load, instead of the path-loss compensation factor.

The max operation pressure was 630 bar; the maximum load was approximately 60 kN and nominal power 750 W.

In this section, an algorithm for the automatic planning of the nominal power, P 0, and maximum UL cell load, U UL, on a cell basis is presented.

However, the amount of power boosting will be limited by a tunable system parameter x, (0<x≤1) which represents the maximum allowed power reduction/increase ratio of the nominal power (beta _{F_{l}}^{k}p_{F_{l}}^{k}), i.e., (p_{F_{l}}^{'k}in left [beta _{F_{l}}^{k}p_{F_{l}}^{k} 1-x),beta _{F_{l} 1-x}p_{F_{l}}^{k}(1+x)right ]).

It is considered that the system will definitely have excess power, because to reach the maximum average hydrogen production, electricity should reach the nominal power of electrolyzer.

In order to maximize the exploited wind power and benefit from a wide range of the wind speed, a novel combined maximum power point tracking (MPPT -Pitch angle control is developed using only one low cost circuit based on Neural Network (ANN), which allows the PMPPT -Pitchanglet an optimal speed to extracontrolmum power when this last is lower than nominal power, andevelopedhe extra power.

A solid state laser was used as the light source, with a nominal power of 4.5 mW and a maximum output of 5 mW at 670 nm.

The 514 nm laser has a nominal power at the source of 50 mW, the maximum power at the sample of 20 mW.