Sentence examples for maximum negative change from inspiring English sources

Activation calculations are computed from both the signal's maximum negative change of voltage (−dV/dT) and the signal morphology of neighboring electrograms.

Pharmacodynamic (PD) parameters were the maximum positive change (Emax+), maximum negative change (Emax–) and the mean change (Eavg) at all seven time points in seated systolic and diastolic BP values.

Similarly, the ∆Pes/∆Paw ratio was calculated as the ratio between maximum (negative) changes in esophageal and airway pressure during two inspiratory efforts.

The mean maximum positive (Emax+) and maximum negative (Emax–) changes from baseline in both systolic and diastolic BP were comparable for sitaxentan and placebo (range 4.8 7.3 mmHg), with three of four geometric mean ratios falling within the equivalence window.

The mean maximum positive (Emax+) and maximum negative (Emax–) changes from baseline in both systolic and diastolic BP were comparable for sitaxentan and placebo (range 4.8 7.3 mmHg) with three of four geometric mean ratios falling within the equivalence window, suggesting that the drug interaction was not clinically significant.

The former stage showed a maximum ∼41-fold downregulation and maximum ∼6.4-fold upregulation, while the latter stage contained a maximum ∼32-fold positive change and a maximum ∼170-fold negative change.

Local activation times (LATs) were calculated as the time from stimulation to the maximum negative rate of voltage change, (d V/d t max of the extracellular atrial electrogram recording of the AP.

LV systolic pressure (LVSP), LVEDP, and the maximum rate of positive and negative change in LV pressure (± dP/dt) were continuously recorded.

When considering the change in trunk flexion, from an maximum negative angle (-37.54°) to a maximum positive angle (18.84°) as head flexion and neck flexion increases, it appears that these students sat with a more neutral trunk alignment as weight increased.

Minimum to lower threshold represented a negative change in NDVI, lower to upper threshold represented no change in NDVI, upper threshold to maximum value represented positive change in NDVI. Figure 10 Digital Elevation Model (DEM) and 3D view developed.

This behavior is not observed in a one-zone bed, where the final steady-state maximum temperature is always higher (lower) than the initial one if the inlet temperature is submitted to a positive (negative) change.