Sentence examples for maximum moisture content from inspiring English sources

The maximum moisture content adsorbed by PKC under fluidization conditions was around 10% (on dry basis).

Due to its hydrophilicity and its polarity, G-E composites showed the greater diffusion coefficient and the maximum moisture content.

Water absorption curves with diffusion coefficient (D), maximum moisture content, Mm and permeability coefficient, P were determined.

Results showed that the minimum and maximum SFC or DFC were in minimum and maximum moisture content on glass and rubber surface, respectively.

This study represents a "worst-case scenario" approach, in that samples are soaked in hot water until the maximum moisture content is achieved.

The verification and efficacy of this technique was established by conducting an experiment on a high-grade IM7/997 carbon fiber-reinforced epoxy to determine the maximum moisture content at saturation and the diffusivity of epoxy.

Results indicate that increases in both gelatin and tannin content not only decrease rates of water uptake, volumetric swelling, and maximum moisture contents of gelatin-based resins, but also increasingly induce relaxation-controlled moisture diffusion behavior, which implies short-term moisture resistance and long-term moisture affinity.

Dry rotary dryer means a rotary dryer that dries wood particles or fibers with a maximum inlet moisture content of less than or equal to 30percentt (by weight, dry basis) and operates with a maximum inlet temperature of less than or equal to 600 °F.

Full (100%) saturation was defined as the maximum gravimetric moisture content achieved in free-draining soils and sediments after rewetting, with 50% saturation defined as half this value.

The maximum soil moisture content, infiltration rate and grain yield of maize and wheat recorded higher in mulching practices over no mulch treatment.

Due to the detrimental effect of RH on siloxane absorption, the maximum allowable moisture content of LFG before purification is 50% RH and moisture removal processes are also required.