Sentence examples for maximum mass transfer from inspiring English sources

The maximum mass transfer coefficient found to occur at approximately 2 3 pipe diameters downstream of the orifice.

The study of kinetics showed well applicability of pseudo second order kinetic model with maximum mass transfer rate in adsorption process.

Increasing the gas and liquid velocities increases the gas liquid mass transfer and the maximum mass transfer coefficient was found to be approximately 1.3s−1.

Rotor diameter, stator inner diameter, and minimum free area of RDC were modified to achieve maximum contact between dispersed liquid phase and gas feed phase, which was necessary to achieve maximum mass transfer.

The amount of gas absorbed during the bubble formation process has been measured to be about 2 10% of the inlet gas phase, and is found to linearly scale with the maximum mass transfer rate.

The optimization of the contractor lies in a maximum mass transfer between the gas (air+ozone) and the liquid (to be treated), and a minimum of the energy cost.

The performance of this type of heater/evaporator for phase-change actuators is shown to be limited by two mechanisms: dry-out of the working fluid in the microchannels due to the capillary limit determines maximum evaporative mass transfer rates, while conduction heat losses out of the evaporators determines maximum evaporator efficiencies.

By applying the optimization method, the dependence of the maximum convective mass transfer enhancement on viscous dissipation can be found.

The variation is associated with the changing position of the inner spray in the throat, with the maximum in mass transfer corresponding to the largest extent of the spray.

Reduced drop mobility is more prominent for drop sizes that are comparable to the tube diameter and is maximum when mass transfer to and from the interface is inhibited.

An experimental investigation of the maximum gas liquid mass transfer capacity OTRmax using the sodium sulphite system was extended to relative filling volumes of 4 16%, shaking diameters of 1.25, 2.5, 5, 7, 10 cm and shaking frequencies of 50 500 rpm for the above flask sizes.