Sentence examples for maximum loads applied from inspiring English sources

Typical maximum loads applied are of the order of 10000 kN.

Also in this case the length of overlap between the plates has been set at 20 mm and the maximum loads applied to the specimens are 700 N for t1 thickness and 900 N for t2 thickness.

The material softening induced by cyclic loadings appeared to depend on the maximum loading applied.

Finally, it is shown that elastic recovery of the silk membranes is an increasing function of the maximum load applied.

Fig. 5 Stiffness by allograft: LGA had a median stiffness between 50 and 75%% of the maximum load applied calculated in 57.86 N/mm (42.68 93.69 N/mm), and CGA in 54.23 N/mm (36.66 61.02 N/mm) in the.

Median stiffness calculated between 50 and 75%% of the maximum load applied was 57.86 N/mm (range 42.68 93.69 N/mm) in the LGA and 54.23 N/mm (range 36.66 61.02 N/mm) in the CGA with no statistical differences being observed between the groups (p = 0.2) (Fig. 5).

The maximum load applied to the WMTA was recorded in Newton before the occurrence of dislodgement.

With this method, the NZ obviously depends on the maximum load applied and thus the ROM.

Both the maximum load applied, and thus the loading history, and the point in time at which the residual displacement is measured, are arbitrarily chosen.

The maximum load applied to cement plug at the time of dislodgement was recorded in newton, and the megapascal, (MPa) values were calculated by the following formula: (1) Debond    stress     (MPa ) = Debonding    force     (N ) Surface    area     (mm 2 ).

These tests determine: a) maximum load applied to the gel without loss of mechanical property, which was 30%; b) viscoelasticity, investigating the liquid solid behavior of the hydrogel at various conditions, which showed a predominantly solid behavior at all frequencies investigated; c) phase angle, showed no change in the elastic and viscous properties, modifying the frequencies.