Sentence examples for maximum loading force from inspiring English sources

The maximum loading force of 344 kN was achieved by the gradual loading.

A maximum loading force between 1 and 6 nN (with an average ~3.5 nN) was applied during each experiment to ensure contact between the cell and mineral surface.

The scan rate of the AFM cantilever and the maximum loading force were set to be 1 2 µm/s and 3 8 nN, respectively.

The jacking test reflected the real-world condition, but there was no strand fracture under the maximum loading force of the jacking device, which was larger than the minimum ultimate tensile strength.

Maximum loading force depending on input parameters Compressive cylinder strength (MPa) Coefficient CRx,c Coefficient γC Maximum force (kN) Designation Value (MPa) Designation Value (MPa) Mean values f cm 27.11 C Rm,c 0.22 1.0 178.42 Characteristic values f ck 24.20 C Rk,c 0.18 1.0 140.55 Design values f ck 16.00 C Rd,c 0.12 1.5 60.47.

Maximum loading force depending on input parameters Compressive cylinder strength (MPa) Coefficient CRx,c Coefficient γC Maximal force (kN) Designation Value (MPa) Designation Value (MPa) Mean values f cm 27.11 C Rm,c 0.22 1.0 177.42 Characteristic values f ck 24.20 C Rk,c 0.18 1.0 139.77 Standard values f ck 16.00 C Rd,c 0.12 1.5 60.13.

A Mullins indicator, in terms of the maximum loading forces over the accumulated residual deflection throughout the loading-unloading cycles, is proposed as a criterion to evaluate the stabilisation of the Mullins effect.

The results indicate that average adhesion forces measured between immobilized cells and the iron oxide surfaces upon retraction vary only slightly (<2 nN) as the maximum load force varies from ~2 to 4 nN.

A maximum load force of 20 nN was found to be optimal and applied to the surface in each recorded force curve.

In this mode, the instrument ramps the Z piezo element of the scanner by a predetermined amount at each sample point over a selected scan area (3 μm) and records the subsequent deflection of the cantilever as it is pushed into (maximum load force 200 pN), then retracted away from the sample surface.

On average, the pre-jacking load was 27.8 kN, about 10.5% of the maximum load strength or 10.8% of the nominal tensile force of the strand.