Sentence examples for maximum load bearing from inspiring English sources

The maximum load bearing capacity of the annealed interfaces reaches about 304 nN, a 40.1% increase from that of the non-annealed ones (about 217 nN).

Further studies show that nut shape has significant effects on load distribution in threads, the optimized nut is designed to make the maximum load bearing ratio of the thread decrease to 30.21%, and thus the service reliability of the bolted joint is greatly improved.

By using these surface treated specimens, adhesion strength was investigated by comparing the maximum load bearing values in the single-leg bending tests.

The former facilitates crack tip blunting, spreading damage in the ligament, while the re-orientation of the fibers perpendicular to the notch plane strengthens the material and improves the maximum load bearing capability.

This study measured the maximum loading bearing capacity of the wallettes and assessed the possible structural rehabilitation in the damaged masonry structures after the reinforcement with the FRP. Figure 1 Geometric configuration of the wallettes, with the applied compressive loading.

This fact, combined with the maximum loading bearing capacity shown by the CW2 and CW3 specimens (as in Table 5), implies that the application of the putty contributes to the rehabilitation, as well as to the increase of the loading bearing capacity, as the result of a better bonding of the reinforcement system to the substrate.

Two failure criteria are included to determine the maximum load-bearing capacity and deflection.

The analyses are planned to initially verify the equilibrium results of the 3DGS model and to predict the maximum load-bearing capacity of the structure by studying the failure mechanism of the system.

The interfacial shear strength and the maximum load-bearing capacity of the tested CNT-Ti interfaces are quantified to be about 37.8 MPa and 245 nN, respectively, both of which are substantially higher than the reported values for CNT-Al interfaces.

Load bearing capacity was maximum at 2.14 ± 0.3 kN for type A specimens under a flat indenter with a displacement of 2.12 ± 0.4 mm.

Rammed earth has the capacity to be load bearing.