Sentence examples for maximum lipid production from inspiring English sources
A maximum lipid production of approximately 592 mg/L was obtained with 4.7 g/L malic acid, 159 mg/L glutamate, 21.7 mL/L of vitamin solution along with 330 mg/L Fe (equivalent to C/N ratio of 132).
The maximum lipid production was obtained at 12% w/w.
When mixed xylose-glucose substrates in the medium were used, both the maximum lipid production and lipid yield per sugar consumed were slightly lower than those attained with glucose alone, but higher than those with xylose alone.
After exhaustion, a pure glucose solution was added, with a concentration and feed rate according to the uptake rate that was calculated for the maximum lipid production rate without citrate excretion.
Satisfactory production, with a maximum lipid productivity of 2.3 g/L, lipid content of 39.8% (w/w), and cell dry weight (CDW) of 5.7 g/L, was obtained at a culture time of 48 h.
The difference of the carbon source consumption for maximum lipid productivity between simulations with and without citrate production was determined and used as a basis for the calculation of the feed strategy for fed batch cultivation.
Out of the three strategies, viz., biomass optimization (BO), lipid content (% DCW), and simultaneous production of biomass and lipid content and their maximization, the third strategy was found to be most effective to obtain the maximum lipid productivity (108.81 mg L−1 d−1), which was approximately 10-fold higher than the autotrophically grown C. minutissima culture.
The maximum CDW was obtained at pH 7.0, while the maximum lipid productivity and content were obtained at pH 6.5.
The maximum lipid yield, especially for oxygenated compounds was in the window of 150 250 °C.
While biomass productivity was 12% higher in the bubble column bioreactor (68.2 gdw m−2 day−1), maximum lipid volumetric production (0.19 gLipid L−1) was found in a gas-lift bioreactor sparged with 6% carbon dioxide due to hydrodynamic and light stresses.
Whereas, maximum lipid accumulation, biomass production and glucose consumption values in multi-response optimization were observed 28.9%, 1271.2 mg L−1 and 89.2%, respectively at optimum level of 16.8 mM NaNO3, 300.9 μM K2HPO4 and 2.6% (w/v) glucose.
