Sentence examples for maximum layer adhesion from inspiring English sources

Furthermore, the maximum layer adhesion was obtained from the copper infiltration process.

Fig. 11 A range of values of legs' cross-sectional area and middle leg's positions, a maximum adhesion force requirement, and b the maximum adhesion force within −0.5 and −0.1 of the maximum normal force/body weight.

This increased to its maximum in layer II/III with 6432.4 ± 1163.5 cells/mm layer II/III.

The attached backpacks have two layers: a cell adhesion layer that grabs on to the cell surface, and a payload layer that carries some chemical cargo in this case, green fluorescent dye.

We found that the maximum adhesion and invasion occurred after 3 hours.

On a slightly rough surface, the oily layer improved adhesion by almost 6 times.

(3) A substrate or subbing layer promotes adhesion of the emulsion to the film base.

The influence of the BNX buffer layer on adhesion was investigated and the results showed that when the N/B ratio of the buffer layer is about 1 1, the adhesive strength of c-BN film to the HHS substrate reached the maximum, about 28.47 N, which is sixteen times higher than that of c-BN film deposited without the buffer layer.

The maximum adhesion obtained in the present calculations was − 21.02 ± 0.49 kJ mol− 1.

The maximum adhesion torque of the clutch-type limited slip device depends on the wheel/rail adhesion conditions.

This linear behavior continued until the maximum force of adhesion was reached.