Sentence examples for maximum laser intensity from inspiring English sources

A lower power of scanning laser (10%) was applied in the prebleaching and postbleaching in order to record continuous fluorescence images, and maximum laser intensity (100%) was introduced to bleach the samples of interest by zooming-in scanning.

For nuclear FRAP experiments, images were captured every 2 5 sec at 3 6% maximum laser intensity and 8 12×1 1.2 ms photobleaching scans at 100% laser intensity were performed on a circular area of 1 µm2 within the center of the nucleus.

For the majority of plasma membrane FRAP experiments, images were captured every 0.2 0.4 sec at 2 5% maximum laser intensity and 10×0.25 0.5 ms photobleaching scans at 100% laser intensity were performed on a circular area of 1 µm2 at the bud tip.

Photobleaching experiments were performed by using a Photonic instruments Micropoint laser system equipped with a 364 nm laser dye, set at 10 to 15 pulses with maximum laser intensity.

By careful target preparation we achieved to place the position of the hole at the edge of one of these lines; this allowed us to image within one specimen regions without laser irradiation as well as regions where the maximum laser pulse intensity had been applied.

At maximum STED laser intensity we reduced the range in the focal plane in which fluorescence was allowed to 4.2 nm and 6.8 nm, in the x- and the y direction, respectively.

We analyzed the performance of the proposed gripper formations with respect to their maximum transport speeds and the laser intensity experienced by the cell that depends on the laser power used [17].

That is, if the probe laser intensity is at its maximum at a nominal temperature and because of a continuous temperature change its intensity decreases and then returns to its maximum again the temperature change is said to be ΔTπ.

If the probe laser intensity is at its maximum at a nominal temperature and because of a continuous temperature change its intensity decreases and does not return to its maximum the temperature change is not ΔTπ but only a fraction of it.

Each PL spectrum, which was excited with a laser intensity of 0.3 wasm2, was normalized to its maximum.

MS/MS spectra were acquired in the positive MS/MS reflector mode by summarizing a maximum of 2500 single spectra (10 × 250) with a laser intensity of 3900.