Sentence examples for maximum iron content from inspiring English sources

However, compared with the results here presented (Figure 3) the study by Dungworth showed, for Roman artefacts, a lower maximum iron content of 2%[21]].

The maximum iron content of approximately 38 at.% was obtained at 28 g/l NaH2PO2 or a metallic salt ratio of 0.5 for Ni Fe P, 0.4 g/l KBH4 for Ni Fe P B alloy deposits.

13, 15 Both articles report a maximum iron content of 25 mg iron/100 g wet tissue for globus pallidus.

They found that catalysts with higher cobalt and iron content showed maximum oxygen reduction reaction (ORR) activity.

For instance, the maximum difference in the specific surface for clays (98 m2/g) was observed in the Elcg horizon, which corresponds to the maximum difference of 5%% in free iron content.

Before March of 1994, soluble iron follows the hydrogen sulfide concentration; afterwards the iron content increased and reached maximum concentrations during November of 1995.

It was determined that an optimal iron content of the catalyst results in maximum yield and that yield depends on the preparation method of the catalyst.

After 1 hour, the iron content of cells, ∼0.2 µg iron/µg protein, reached half of the maximum value.

In fact, as time progresses, the average ferritin iron content increases, as well as the number of ferritins operating at maximum capacity, conditions that occur in vivo during iron overload and which are accompanied by the formation of a degraded, toxic product called hemosiderin.

The D values in the PrCo1 − x Fe x O3@700°C samples systematically decrease with the increasing of iron content, whereas in the PrCo1 − x Fe x O3@800°C series, this parameter goes through the maximum at x = 0.5.

Results are shown as mean ± S.E.M. with n = 3. Significant increment of total iron content in the serum was noted during the course of the study (P = 0.0001) with maximum increase of 156.87% after 12 h with single shot of N.O.