Furthermore, the maximum intensity of lines b, c, and d in Fig. 4 was increased in turn.
The altitude of the OH nightglow layer is closely related to that of the O2 a1Δ) emission and some level of co-variation of the maximum intensity along the line of sight is observed.
where K is the shape factor (0.9 [17], λ is the X-ray wavelength (1.54 Å), B is the broadening of the diffraction line measured at half maximum intensity (FWHM), b is the line width originating solely from instrumental broadening, and θ is the Bragg angle corresponding to the (111) plane.
The shaded regions indicate each MHW detected using the Hobday et al.2 definition, the red-shaded region is the largest event (by maximum intensity) and the blue line indicates the longest event.
At the sample azimuth Φ = 90°, the Al2O3 (006) peak can be optimized to have a maximum intensity such as a line curve in Fig. 3e, but it shifts rightwards with a large reduction of its intensity when φ is optimized to the Bi2Se3 (006) peak.
We found that the jets typically undergo two phases: at the first phase the O VI lines show a brief intensity enhancement and narrowing, while the H I Lyα line is not enhanced, and the second phase, about 25 minutes later, when the H I Lyα line shows maximum intensity enhancement and narrowing, while the O VI line is relatively unchanged.
The 488 nm laser line was used at 6% of maximum intensity and the 543 nm laser line with an emission range of 547 703 nm was used at 30% of maximum intensity.
A striatal volume was measured for the template and individual mice by choosing a threshold of 50% of the maximum intensity of the striatum (vertical line), which resulted as a striatal volume of 22.3 mm3 and 17.2 mm3 ± 20%, respectively.
Within 3 minutes, colors form at or above the swipe line, developing maximum intensity after another 3 5 minutes.
Diffraction patterns were analyzed by comparison of lines with maximum intensity corresponding to different crystalline phases.
The first contour encircles the region of maximum intensity and the remaining contour lines are plotted at 3 dB decrements in intensity.
