Sentence examples for maximum injection rate from inspiring English sources

The maximum injection rate was 90 l s−1, which resulted in an injectivity index of 3.6 l s−1 bar−1.

IV contrast material was injected by means of an automated power injector with an injection duration of 20 s (maximum injection rate of 5 ml/s), and 20 ml of saline was subsequently injected at the same injection rate.

Given a certain pressure threshold, a maximum injection rate is estimated from the semi-analytical model and is then fed to the numerical models.

In fact, a naive estimation from solar wind parameters, in particular the largest in situ observed values of the interplanetary magnetic field B (=1.0 × 102 nT; Russell et al. 2013) and solar wind speed V (=2240 km/s; Skoug et al. 2004), made by extending the empirical relationship reported by O'Brien and McPherron (2000), gives a maximum injection rate of ring current energy of 9.8 × 102 nT/h.

Time to threshold and the maximum injection rate reached were recorded.

Intended contrast medium injection rates were always reached including the maximum injection rate of 6.7 ml/s.

However, these maximum injection rates are above the injection rates used in our study for both the high and moderate concentration groups and data produced by the contrast medium injection pump confirm that the required injection rates were always reached.

Possible limitations requiring further research includes the design for maximum charge injection rate, which is thought to be limited by corona breakdown, again a trade-off in air media between charging electrode and liquid sheet.

Maximum modeled injection rates predict minima for storage costs in a typical basin in the range of $2-7/ 2-7/CO 2(2005 U.S. $) depending on deptonand basin COaracteristics in our base-case scenario.

The constraints for the injector and producers are as follows: (1) the minimum production bottom-hole pressure is 2588.14 psi, (2) a maximum water/LS water injection rate is 5000 bbl/d and (3) a maximum gas injection rate is 18,135,000 ft3/d.

It is helpful for a landfill operator to be able to estimate the rate at which the landfill can accept leachate (the maximum infiltration or injection rate), the storage capacity of the landfill and the leachate retention time.