Sentence examples for maximum injection pressure from inspiring English sources
The experimental results indicate that the maximum injection pressure in the bolt is 2.5 MPa without link enhancement and 8.3 MPa with the enhancement.
Test He1 had a higher maximum injection pressure and stronger pressure fluctuation compared with that of test Ho4 during the CGA fluid injection.
XG solution had a maximum injection pressure of 0.242 MPa, which was approximately one-third of that of the CGA fluid.
Table 2 Analysis simulation parameters Injection well number Injection position Injection rate (104 Maximum Maxinjectionction pressure (bar) Target pressure (bar) 5 The top 50 46 410.
As the temperature increased, the Colloidal Gas Aphron fluid became less stable; the maximum injection pressure and tertiary oil recovery of Colloidal Gas Aphron fluid decreased.
When the injection rate was increased from 2 to 3 mL/min, the corresponding maximum injection pressure increased from 2.15 to 2.73 MPa.
While pressurizing the intervals at maximum injection pressures of 5 to 6.3 MPa, we simultaneously monitored fault displacement, pore pressure and injection flowrate in two boreholes.
The CO2 was injected at a constant rate for each development strategy, with the maximum bottomhole injection pressure limit of the formation fracture pressure.
Accurate determination of the formation fracture pressures is a key factor controlling the maximum allowable injection pressure during operations.
Using them as inputs of 2D finite-element coupled hydro-mechanical models of a reservoir-scale fault zone, the key role of the spatially-varying DZ stiffness and Biot's coefficients are highlighted: neglecting them might lead to a high over-estimation of the maximum sustainable injection pressure (by nearly 50% in the considered cases).
The horizontal well constraint for the injector is 1000 bbl/day, and the maximum allowable injection pressure is 7000 psi. Figure 8 shows that the CO2 injection rates rapidly decrease from the initial constraint value and the well then is switched to injection pressure control.
