Sentence examples for maximum improvement in from inspiring English sources
The results obtained on the non-magnetic specimens by this approach for different magnetic field and process duration confirm that the finishing capability of the process is greatly improved, and yields a maximum improvement in finish of 41.7% and 43.5%, respectively while the previously reported results are 6.7% and 24.2%.
For interconnect trees, the maximum improvement in delay for optimally placed interplane vias is 19%.
Dr. Amdahl also formulated what became known as Amdahl's Law, which is used in parallel computing to predict the theoretical maximum improvement in speed using multiple processors.
It is important to identify and pursue only those changes, which give maximum improvement in the perceived value.
Experimental findings reveal that the maximum improvement in joint capacity occurs at a rate of 3.35 m/s.
The results demonstrate that of all the dosages tested, 2.5 mg/kg rendered the maximum improvement in behavioral outcomes and tissue spared.
This was consistent with the tensile test results in which maximum improvements in the strength, stiffness and toughness were obtained for the 0.5 wt% MWCNT-nanocomposite.
The velocimetry data showed that the curved orifice-plate geometry successfully generated an inclined jet within the channel, and maximum improvements in the area-averaged heat transfer coefficient of 495% (relative to a channel containing no obstruction) were measured.
The experimental results reveal that, when MEDM is compared with the sole elevation-dependent model and the carrier-to-noise power density ratios (C/N0 -dependent model, the maximum improvements in ambiguity resolution suC/N0 -dependent) in 5, 6, 7, 8 available satellites cases are about 0.2%, 13%, 3%, 1% for B1 frequency, and 1%, 6%, 2.5%, 0.2% for B2 frequency, respectively.
The maximum improvements in precision for symptoms, diseases, and medications were 0.303, 0.333, and 0.180.
Maximum improvements in the bearing capacity and strength of the Portland cement-treated material were achieved when blended with 3% cement for both standards.
