Sentence examples for maximum impact strength from inspiring English sources

The maximum impact strength at 77 K is attained by introduction of 10 wt% H30 with an improvement of 26.3% over that of pure epoxy resin.

HDPE/CaCO3 composites undergo a brittle ductile transition in the range Vc=0.1 0.3, and the maximum impact strength achieved depends on d and size distribution.

The optimized value for the maximum impact strength of PP DSF composite was found at 50 wt% DSF content and fiber size range of 250 500 μm with 0 wt% MAPP.

Although the encapsulation is incomplete, maximum impact strength and maximum strain at break in tensile test can be obtained when certain combinations of SEBS-gMA and SEBS are used.

In the case of the impact test, maximum impact strength was obtained for rubber particles with a 0.25 μm diameter regardless of the rubber phase contents, and only a modest improvement of the impact strength was obtained for blends containing 0.15 or 2 μm particles.

High density polyethylene (PEHD) and isotactic polypropylene (iPP) blends exhibit a maximum in impact strength at a specific mixing ratio.

A maximum in impact strength was also observed, but all compatibilized samples exhibited a higher impact strength than the non-compatibilized one.

The maximum relative impact strength of the welded samples is about 29.48 % of the impact strength of base material which is obtained in a specimen welded at 1570 rpm rotational speed and 42 mm/min traverse speed.

The highest value of the mass fraction of austenite – stable at room temperature – occurs at intermediate tempering temperatures and this condition corresponds to a maximum in impact strength and a minimum in tensile strength.

In case of direct melt blending process, the maximum tensile strength with minimum impact strength is obtained.

Impact strength of the base material was also obtained 36.6 kJ/m2, while at the optimum conditions, the maximum amount of impact strength was achieved about 10.8 kJ/m2.