Sentence examples for maximum illumination intensity from inspiring English sources
A small increase on series resistance of 5%% was observed after successive measurements but it is not detrimental to the interpretations because the V oc induced by the maximum illumination intensity remains almost the same at each step of the measurement timeline.
The maximum illumination intensity is approximately 3,000 μmol photons m−2 s−1 and can be adjusted between 0% and 100% of maximum intensity in 1% increments.
The fluorescence chamber provided a one-second pulse of continuous red light (3000 μmol photons m-2s-1 maximum light intensity) for illumination.
When the light is completely shut off, the two electrodes are separated again, and the electron transport returns to the tunneling regime (G ≪ 1 G0), as shown in state 4. To understand the dependence of conductance on the light intensity, we perform experiments where the maximum light intensity in each illumination circle is gradually increased.
The maximum light intensity on its surface does not exceed 1000 lux, and the illumination time for one capture is approximately half a minute.
Uniformity of illumination across the full cultivation area was confirmed through detailed light meter measurements and achieved a maximum light intensity of 450 μmol photons m−2 s−1 at the microwell plate level.
The velocity values represented in Figure5 then depict the average velocity values at a maximum distance of 310 nm from the wall after correcting for exponential illumination intensity inherent in nPIV[28].
Initially, the maximum local temperature on the surface of the single Al@Cu2O was calculated as a function of illumination intensity and wavelength (Supplementary Fig. 6 and Supplementary Note 1), which resulted in negligible temperature increase under illumination conditions.
These genetically encoded reporters were first described by Hanson et al. (2004) as redox potential sensors with two fluorescence excitation maxima, thus permitting ratiometric analysis that minimizes errors associated with variations in indicator concentration (roGFP expression), illumination intensity, and cell thickness.
CFL bulbs can also be slow to reach maximum illumination.
The influence of the illumination intensity has also been considered.
