Sentence examples for maximum hydrolysis yields from inspiring English sources

Table  3 summarizes the data for the predicted kinetic parameters regarding initial hydrolysis rates and maximum hydrolysis yields.

Other studies about algae biomass pretreatments are under way, in our laboratory, to increase the maximum hydrolysis yields.

The maximum hydrolysis yield was the same at 100 FPU but is not shown here.

Nonionic surfactant Tween-80 improved enzymatic hydrolysis yield of fines in addition to 50%% increase at 10 FPU and reduced enzyme dosage to obtain the maximum hydrolysis yield.

The maximum hydrolysis yield was around 44%% of OD (oven dry mass basis) fines and was found at 50 FPU of the enzyme.

The hydrolysis capacity of CTec 2.0 showed the maximum hydrolysis yield at each cellulase dosage from 5 to 25 mg/g, followed by the LLC 4 and then # 7. The hydrolysis yield increased with the increasing cellulase dosage but the increase almost ceased or slowed down due to the increasing glucose inhibition on the cellulase enzyme activity.

The enzyme dosage of 50 FPU for the maximum hydrolysis yield is too high to produce sugars from fines economically since other researchers reported that enzyme less than 10 FPU is sufficient to reach the highest conversion yields of pretreated corn stover, bleached hardwood and softwood pulp, or copy papers (Chen et al. 2012; Roche et al. 2009).

Feedstock with low lignin (<20%) content was desirable for maximum hydrolysis yield.

The maximum hydrolysis yield of glucan (82%) was obtained after pretreatment for 28 days.

The predicted maximum hydrolysis yield for all enzyme preparations followed the same pattern presented in Figure  4.

A variety of pretreatment conditions, with desirability 1.0 were selected for maximum hydrolysis yield at lowest catalyst level (1.0% catalyst).