Sentence examples for maximum height corresponding from inspiring English sources

Students are challenged to grow the mountains to their maximum height (corresponding to the maximum change in light level) while maintaining a viable population of plants on each side.

The behaviors of these characteristics were well explained by diurnal and seasonal variations in the critical frequency and maximum height of corresponding ionosphere layer in HF reflection point.

In other words, this analysis definitely demonstrates that direct impingement, in the case of PVD techniques, has a minor role in the axial growth because it contributes to a maximum NW height corresponding to the thickness of the planar layer only.

The true reflection height was lower than the corresponding maximum height by approximately 40 km.

Diurnal and seasonal dependence of the true reflection height in the F1 and F2 channels was determined mostly by the behavior of a corresponding maximum height (see middle and right columns of Fig. 1c, e).

Once boundary layer effects have been included in the model, the radius corresponding to maximum wind speed becomes a function of elevation, the height corresponding to maximum wind speed becomes a function of the radial coordinates and the shapes of the speed profiles become changeable with the radial and vertical coordinates.

The height corresponding to this maximum was defined as the correlation height, which for most bright points was found to range below 20 Mm.

Figure 1d, e presents dependencies of the critical frequency and maximum height for the electron density profile corresponding to the coordinates of the ionospheric reflection point.

This correlates very well with general observations about fluorescence images that indicate a maximum image contrast at the Z-stage height corresponding to the focal position.

The simplified wavelet leads to acceptable accuracy compared with a corresponding real record when the maximum height of the sloshing wave is examined; however, significant underestimation is detected for the calculation of the base shear.

There is a broad range of heights from ∼1.0 5 nm with a maximum of ∼3 3.5 nm, consistent with the average height corresponding to a high MW oligomer.