Sentence examples for maximum generator current from inspiring English sources

Never use a cord that has a lower current rate than the maximum generator current.

The generator current was 0.9985 mA and calibration was performed using a solution of arsenious acid.

Assuming cosφ = 0.9 for the wind generators, the maximum short-circuit current contribution in kA is calculated as (9): left{ {begin{array}{*{20}l} {I_{{k{text{max}}_WTG}}^{prime prime } = frac{{S_{b_WTG} }}{{sqrt 3 U_{n_WTG} }} cdot 1.1 simeq 0.86} hfill {I_{{k{text{max}}_WTG_A}}^{prime prime } = frac{{S_{b_WTG_A} }}{{sqrt 3 U_{n_WTG_A} }} cdot 1.1 simeq 3.7} hfill end{array} } right.

Comparative results demonstrate that the proposed control strategy can be employed to more effectively capture the maximum marine current power and to considerably eliminate the generator power fluctuations as compared with a conventional second-order sliding mode control method.

Though the minimum norm estimate tends to result in a blurred picture of cortical activation, the location of the maximum estimated current has been shown to reflect the location of the generator of neural activity with good accuracy (<20 mm) (Babiloni et al., 2000; Hauk, 2004; Komssi et al., 2004 a ).

The couple of generators can orientate themselves in the current direction, to capture the maximum of current power (the water turbine can be asymmetric and, thus, fully optimized).

Currents were normalized to the maximum peak current for comparison.

The probe (generator electrode major axis ca. 1700 nm and collector major axis ca. 700 nm) was placed directly above a single thylakoid membrane at a distance where the maximum collection current was detected (as above) and then scanned laterally across the sample at a constant height in the G/C mode.

The RX introduces the sixth generation of Toyota Hybrid Synergy Drive, the best yet at squeezing maximum current through the electric motor-generators — whether they're powering the car or capturing energy from braking — without the heat getting out of control.

Commercial electroporation pulse-generators are typically limited to a 50 A maximum current and surpassing this threshold leads to a generator hard-reset for recalibration or component restabilization [ 8].

Map of maximum current speeds and graphs of maximum current speeds at four points of interest.