Sentence examples for maximum furnace temperature from inspiring English sources

Thus, to control the maximum furnace temperature, the circulating solids flux must be increased beyond what is required to close the heat balance across the CFB loop.

The dependence of the nanowire average length and diameter on the growth temperature is shown in Fig. 5. Figure 5 ZnO nanowire diameter and length measured as a function of maximum furnace temperature under fixed reaction conditions of: 100 min reaction time, 760 Torr, and Ar flow rate of 70 sccm.

For the conditions investigated, limitation of the maximum furnace temperature to 1273 K yields that 48%, 56%, and 70% are the highest possible inlet oxygen concentrations if the external circulation flux rate is limited to 10, 20, and 30 kg/m2/s, respectively.

While maintaining the same dense bed temperature as in the air-fired case, an increased inlet O2 concentration in the oxy-fired case leads to dramatic increases in the maximum in-furnace temperature and maximum heat extraction flux rate.

This stack consisted of four anode-supported single cells connected in series, and generated a maximum power output of 421 mW (total active area: 1 cm2) at the furnace temperature of 750 °C, which powered an USB fan stably.

For cooling, furnace was turned off while Ar flow continued till the furnace temperature comes down to room temperature.

When furnace temperature reached 775 °C, carbon source gas C2H2 was allowed for 10 min to flow in the furnace.

The first point is for no-calcined sample and the temperature is the furnace temperature.

During this process, the furnace temperature is adjusted to the desired experimental temperature.

The reactor temperature was measured as close to 700°C (the preset furnace temperature) using a thermocouple.

The furnace temperature was gradually increased from room temperature to 550°C in 1 hr.