Sentence examples for maximum electrocatalytic activity from inspiring English sources

The maximum electrocatalytic activity of biosensor was achieved with 0.4 wt% PVA solution.

It has been found that Pt has distinct electrocatalytic activity on specific crystalline planes for the electrochemical applications [25], which suggests that the maximum electrocatalytic activity may be achieved by controlling the single crystallinity in fabricating the Pt nanomaterials.

The optimal concentration of the SNS required for maximum electrocatalytic activity towards HER was obtained by adding different volumes of SNS (from 0 to 50 mL L−1) into the bath.

The results obtained demonstrate the presence of the spinel structure on all types of electrodes studied and that the oxide, with a cobalt nickel atomic surface ratio equal to two, has the maximum electrocatalytic activity.

The low-index facets of the single-crystal nanostructure of the PtNCs provided the superb triiodide reduction ability to maximum electrocatalytic activity, which promoted the charge-transfer rate at the electrolyte electrode interface and the exchange rate of the electrolyte and thus increased the J sc and resulted a superior PCE.

Different concentrations of PVA solution were used to select a particular concentration of PVA solution for obtaining the maximum biosensor electrocatalytic activity.

Due to the rapid charge transfer ability and electrocatalytic activity, maximum front and rear efficiencies of 7.64% and 4.95% are measured for the DSSC with FeSe alloy electrode in comparison with 6.97% and 3.56% from Pt-based solar cell.

Electrochemically oxidized Ni shows excellent BOR electrocatalytic activity with a maximum of seven electrons exchanged and a transfer coefficient up to one.

Two important findings can be observed in Figure 4: First, the nanofibrous morphology strongly enhances the electrocatalytic activity as the maximum current density significantly increased from 6 (in case of NPs) to 25 mA/cm2 (in case of NFs).

This result might be explained by CuO film providing abundant active sites improving the electrocatalytic activity for NO 2 -.

The electrocatalytic activity for OER is closely related to the active sites and electronic conductivity of the catalysts.